Chain Plates

I and Chris ( american chris haha ) were working on getting the positon of the chain plates in place. As you can see on this photo we found out where they had to go and than we cut out the foam at that place. We went as far as we could getting the foam out but we Stopped  before hitting the glass.

Once the foam was out we started to mix the glue and started to put it onto the glass where the chain plates will go.The glue had to be thick enough so it dose not slide down off the glass.                     

here is a photo of us putting the glue on              

Once everything was done we got the Glass plates into positon and was held into place by the blocks which were gently screwed onto the foam ( the screws were short enough so they dont go into the glass ). We also put down mdf wood intop of the plates just so the blocks can rest on it and give us more hold when the screws went on.